BEFORE PUMPING

• Thoroughly wash your hands with soap and water before touching any pump parts.
• Check each component for wear or damage before use and replace parts when/if necessary. We recommend changing parts every 1-3 months. 
• Make sure that all components that come into contact with breast milk are properly sanitized. 
• Assemble the breast shield, diaphragm, and bottle according to the instructions and connect to the pump body via the tubing. (please see the quick start  guide instructions)
• Ensure tubing is tightly connected to prevent air leakage.
• Check battery level before use to ensure the device is fully charged.
• Massage the breast for about 5 minutes with a warm towel to promote expression.

PUMPING

• Place the breast shield on your breast so that your nipple is centered (please see the breast shield size guide to get the correct breast shield size)
• Press and hold the power button for 3 seconds to turn on the pump.
• Your pump has three pumping modes: Stimulation, 2 Phase, and Expression Mode.
  
• Press the (M button) to switch modes.
• It is generally recommended to start in Stimulation  Mode in vacuum 1 and slowly increase the vacuum until you have reached a letdown and the milk has started flowing. Once this happens, switch to Expression Mode starting on vacuum 4 or 5 (or the same level you were using in Stimulation  Mode).
• You can choose your desired Stimulation  / 2-phase level to stimulate milk by pressing the level up and level down buttons. 
• When your letdown is achieved in Stimulation Mode, switch to Expression Mode or 2-Phase Mode, depending on the mode that works best for you. In Expression Mode, you will get slower, more intense suction. In 2-Phase Mode, it will mimic the way baby feeds from mom, with quicker weaker suction, followed by deeper suction at the end of the mode.  
• After switching to Expression Mode or 2-Phase Mode, you can choose your desired vacuum level by pressing the level up and level down buttons. 
  

TIPS

• You do not need to use all pump modes and levels ( 2-Phase, Stimulation , and Expression mode). Only use the levels that are comfortable for you. 
• You can pause your pumping session at any time. Simply press the pause button and press again to continue with your pumping session.
• When you have finished expressing, press the power button to turn off the breast pump and carefully remove the pump body from your breast. TIP- After switching off the breast pump, break the seal between the breast and the breast shield with your finger, and then remove the pump from your breast.